Stump Grinding · Dana, NC

Stump Grinding in Dana, NC.

Near Dana the access and the slope drive the job. Median lot about 0.96 acres; county grades run 0–95%, so equipment access and safe drops set the pace.

40.2%

Ashe slope

0–95%

County slope range

0.96

Median lot (ac)

24hr

Callback

Prefer to talk? (828) 555-0146

What does stump grinding involve on a Dana, NC property?

Stump Grinding on a Dana property is shaped by terrain and access as much as the trees or brush themselves. The median Henderson County lot near Dana is about 0.96 acres (48.2% are an acre or more), and Henderson County ground runs steep — county slopes span 0–95% — so getting equipment to the work, dropping safely on a slope, and hauling material off is the real job. We walk the property, flag the hazards and the access, and price the work from what's actually there.

Stump Grinding in Dana: terrain and access set the price

On flat ground, stump grinding is volume. In Dana it's access and slope. Henderson County lots run from valley flats up to 95% grades, and The median Henderson County lot near Dana is about 0.96 acres (48.2% are an acre or more). A tree leaning over the house, brush on a bank too steep to walk, blowdown across a drive after a storm — each one is a different problem of how we reach it, how it comes down safely, and where it goes after. We carry the equipment for slope work and we don't guess at a price over the phone; we look at the actual property.

Storm country — Helene and what WNC ground does after rain

Western North Carolina is storm country, and the 2024 Helene flooding showed what saturated mountain ground does: trees on soaked slopes go over root-ball and all, banks slough, and debris piles in the draws. After a storm the work near Dana is often half cleanup, half making the slope safe again — clearing the blowdown, then dealing with the bank or the washout it leaves. One crew that also does drainage and grading means we can clear the mess and fix the ground it left.

See the full service on our tree & storm cleanup page, and the wider Dana service area.

Dana groundNC089

Near Dana the access and the slope drive the job. Median lot about 0.96 acres; county grades run 0–95%, so equipment access and safe drops set the pace.

40.2%

Ashe slope

0.96

Median lot (ac)

Henderson County ground

The Henderson County soils behind stump grinding near Dana.

Dominant USDA-NRCS series in Henderson County (survey NC089) — the slope and drainage numbers that decide how stump grinding has to be built on a Dana lot.

Henderson County dominant USDA-NRCS soil series (survey NC089) — source: USDA-NRCS Web Soil Survey
Soil series	Typical slope	Slope range	Drainage class	What it means
Ashe	40.2%	8–95%	Somewhat excessively drained	Wall / slope work
Evard	28.1%	6–70%	Well drained	Wall / slope work
Porters	33.9%	8–95%	Well drained	Wall / slope work
Tusquitee	16.7%	2–45%	Well drained	Wall / slope work

County slope envelope: 0% in the valleys to 95% on the steepest series. We confirm your Dana lot's grade and drainage class on the free site walk.

What it costs

What stump grinding costs in Dana, NC

These are typical Western North Carolina market ranges, not a Maidenhair Landscaping quote. North Carolina construction runs about 12% below the national average, but our mountain terrain — 15–40%+ slopes, weathered bedrock and saprolite, clay, and tight access — pushes most jobs toward the high end of every range. A flat infill lot sits low; a steep escarpment lot sits at or above the top. Your exact price comes from a free on-site estimate.

Tree & storm cleanup — typical Western NC ranges (published market data, 2026-06-24)
Item	Typical WNC range	Notes
Tree removal (per tree)	$400–$2,000	small to large; very large or hazard trees $2,000-$4,000+
Emergency / storm removal	$600–$4,000	tree on a structure or hazard access; insured
Stump grinding	$75–$400/stump	~$3-$5 per inch of diameter

What drives it: tree height and diameter, lean and proximity to the house or lines, equipment access on a slope, hazard/emergency conditions, and haul-off vs chip-on-site.

Source: published WNC/NC market ranges via angi.com and homeguide.com . Exact pricing on your lot comes from a free on-site estimate — call (828) 555-0146.

How it works

How we do it in Dana.

Walk & flag

We walk the Dana property, flag hazards, lines, and how we reach the work.

Drop & secure

Trees and brush down safely on the slope, rigged where a free drop isn't safe.

Clear & haul

Debris chipped on site or hauled off, stumps ground below grade where you want them gone.

Reset the site

We leave the ground clean and, where a bank was cleared, stable.

FAQ

Stump Grinding in Dana: common questions

How much does tree work cost in Dana?

There's no flat rate, because the cost is set by the tree's height and lean, how close it is to the house or lines, and how we reach it on a Dana slope. A small open-yard tree is the low end; a large hazard tree leaning over a structure on a bank we can't drive to is the high end. We give a firm price after we look at the actual tree and the access — never a phone guess.

Do you do emergency and storm work near Dana?

Yes. A tree on the house, across the driveway, or hung up over a line after wind, ice, or a storm is the work we prioritize. We're an insured, Hendersonville-based crew, so most Dana-area emergencies get a fast callback and a same-week response — sooner when it's a safety hazard.

Are you local to Dana, and are you insured?

We're Maidenhair Landscaping, a Hendersonville-based, owner-run crew — general liability insured — covering Dana and 6 WNC counties. We're a newer outfit doing real work the right way; we'd rather earn Dana on the quality of the wall and the honesty of the quote than on a stock photo and a fake review. Free on-site estimate, 24hr callback.

Free estimate

Need stump grinding in Dana?

Tell us what you're dealing with — we'll walk the lot, read the soil and grade, and put a real number in writing, free.

Prefer to talk? (828) 555-0146